Molten salt pump can work properly, but the flow and head of molten salt pump are inadequate. If so, it can’t meet the requirement of transferring heat. It is performance parameters of molten salt pump that they can’t meet the requirements. They are the common fault that the molten salt pump is using in the process. The common causes and treatment methods are as follows:

    1 impeller of the molten salt pump is damaged, you should be replaced by a new impeller.
    2 revolutions are insufficient, you should be required to increase the speed of Warwick molten salt pump.
    3 outlet valve of molten salt pump is not fully open, you should fully open the valve.
    4 there is a blockage in the pipe which it should be cleared to block the object.
    5 medium density does not match with pump requirements. You should be re accounting or replacement of the appropriate power’s motor.
    6 device head does not match with pump head, you should try to reduce the installation height of the pump or increase the level of molten salt.
    If you want to know more about the flow and head of the molten salt pump, please to see official website of Warwick pump company: www.hwpump.com