High temperature submerged pump
    Jinan Warwick pump industry specializing in the production of high-temperature liquid pump, which is a centrifugal liquid pump, the over-current components being submerged in the medium is transported, transmission shaft through a supporting piece and bearing components to maintain its stability, the weight of the pump and the axial force through a bearing transferred to the basic, according to the requirements of the process equipment, high temperature liquid pump should has certain depth of insertion. The structural design of the pump is mainly consider the following two factors:
    1 dielectric properties
    According to the corrosive, volatile, solid particle size, concentration and so on, to determine the impeller type, bearing, sealing and washing methods.
    2 use conditions
    Reasonably determining the requirements of high temperature liquid pump pumping medium temperature level, determine the bearing type, cooling structure, there is no insulation jacket. According to the pump, pump body insert depth, belonging to at any time may start the liquid pump, the pump body is inserted into the depth must be long enough to allow the liquid submerged pump body, ensure the liquid pump can always start, such as sulfuric acid used in the production of pump and wet smelting liquid pump. In this condition, the liquid pump pump body insert depth can be designed relatively short, through the installation of suction tubes insertion depth, ceiling net liquid. The pump body is inserted into the depth of the relationship, and is conducive to improve the pump's reliability and reduce the cost.
The selection of questions about the high temperature liquid pump, please call the Ji'nan Warwick pump industry consultation.