The reliability of molten salt pump is essential for the life of the molten salt pump. The quality of manufacture and the level of debugging affect the service life of the molten salt pump. Because of this, parking of the molten salt pump should pay attention to the problem.
    1, You should pay attention to temperature pump bearing, you should not exceed 35 degrees than the outside temperature, but the maximum should not be greater than 75 degrees.
    2, The internal cup should be filled with lithium grease. If so, you can ensure normal lubrication of the bearing.
    3, You should change the grease in the first month of work or running 100 hours that grease is in the Warwick molten salt pump bracket bearing cup. Later, you should replace every 2000 hours.
    4, You must regularly check the flexible coupling and pay attention to the temperature’s rise of the motor bearing.
    5, If you find noise and unusual sound in the process of moving, you should immediately park to check.
    6, The pump should be carried out cycle check after every 2000 hours of work. The gap between impeller and pump body (or pump cover) can’t be too large. The maximum value of the gap shall not exceed 0.5 mm. If the gap exceeds 0.5 mm, you must replace the impeller or the front cover.
    7, You should check the packing seal after the pump works 6 hours. According to the degree of wear, you can be judged installation quality of Warwick molten salt pump.
    If you want to know more about the daily maintenance of molten salt pump, you can log on Warwick pump company official website: www.moltensaltpump.com.