The main content of molten salt pump’s selection is based on the head, flow, change rules and system requirements for exchanging heat to determine proper molten salt pump types, types and units. The selection of molten salt pump is mainly based on the design parameters of project planning. Selecting type of molten salt pump is based on the following aspects:
    1, You must be based on the needs of production to fully meet flow and head (or pressure) requirements in the production process.
    2, You should select the type of pump that it has good performance. It is adapt to flow and head. Firstly, we should select the molten salt pump of high efficiency and using a wide range in series of products. When there is multiple type of pump to select, you should analyze technology economy. Then you can select the best one. When the series products can’t meet the requirement of selection, you can be based on the rules of procedure to design new products. When the head largely changes in the engineering requirements, you should choose the pump of H-Q curve steep drop type. When the flow largely changes in project requirements, you should choose pump of the H-Q curve flat type.
    3, We should try to make the selected pump in the range of high efficiency that it works in designed (rated) operating point near the operating point. It can normally work in the pump unit of designing conditions. If so, it would not occur cavitation, vibration and overload and so on.
    4, The pump has advantage of the average high efficiency, low energy consumption and low operating costs.
    5, The selected pump model, the number of the whole system of investment (the cost of equipment and construction and installation engineering total investment) of the province.
    6, Our pumps have advantage of easily operating, easily working, managing and maintaining.
    7, Pump types and units should meet between the lower pump flow coordination requirements for cascade operation of the pump. If so, it can avoid as far as possible and reduce inadequate or overfull flow.
    8, The large-scale molten salt axial flow pump should have the device model test data. When the prototype has a larger change, the pump should test the device model.
    If you want to know more about how to select the type of molten salt pump, you can log on Warwick pump company official website: www.moltensaltpump.com