Reasons and solutions of molten salt pump that it does not f

    After starting the motor of the molten salt pump, the motor can work normally, but the outlet pipe of the molten salt pump is not liquid. It is a common failure in the process of using molten salt pump. The common causes and treatment methods are as follows:
    1 the air is left in the pipe or pump and the molten salt should be added the molten salt to remove the air.
    2 If the valve of inlet or outlet side pipe is closed, you should open the valve.
    3 The device head of molten salt pump is higher than the maximum pump head, it should be replaced by a high head’s pump.
    4 If the direction of impeller rotation is wrong, the motor should be corrected.
    5 the suction pipe is too small or debris clogging, it should improve the installation’s height of molten salt pump and you should remove the blockage.
    6If the speed does not match, you should make that the motor speed matches the requirements of Warwick molten salt pump.
    If you want to know more about the content of molten salt pump out liquid, please to see official website of Warwick pump company: www.hwpump.com